• Cart

    No products in the cart.

Paste tile adhesive CP6

Ready-to-use dispersion tile adhesive with high performance and adhesion based on styrene acrylic resins is used for installing tiles inside the building on the wall using a thin layer method.

standards:

  • ISIRI    12492
  • BS EN  12004

physical state:

Dough

Color:

white

Special Weight:

0.02  1.86

Chlorine ion:

does not have

packing:

It is available in 5, 12 and 25 kg buckets.

100تومانAdd to cart

Implementation method

Spread the glue on the surface with a toothed spatula with a thickness of 3 mm, and if the back of the tile is patterned or uneven, apply the glue on the back of the tile with a spatula.
Install the tile by applying pressure on the surface and move it slowly in place for better adhesion while pressing.
If the surface layer of the glue dries, it should be troweled again before installing the tile.
In normal temperature and humidity conditions, the maximum running time is 20 minutes.
After installation, at least 60% of the back of the tile must be covered with glue, otherwise, a trowel with deeper grooves should be used.
Do not use at temperatures below 5 degrees Celsius.
The best temperature for glue drying is above 15 degrees Celsius.

Technical services

Aryashimi’s technical department is ready to cooperate and provide services in order to provide technical advice and how to use its products correctly.

Storage period

It can be used for up to 12 months if kept in the recommended conditions and in the original packaging.

Maintenance

It should be kept away from cold and frost and direct sunlight and at a temperature of +5 to +35 degrees Celsius.

Benefits of use

  • Speed and ease of implementation and thus reducing implementation costs
  • Excellent adhesion with favorable properties against water
  • Appropriate flexibility and resilience against the limited movements of the building.

Consumption

According to the surface under the work, the amount of unevenness and the type of grooves behind the tile, about 3 to 4 kilograms of ARYASET-CP 6 are needed to cover one square meter.

strapping

The curing time for tiles installed on water-absorbing sections is after 24 hours, and for non-absorbing sections or tiles with large dimensions, it takes a longer time.
Use waterproof sealants in bathrooms and sanitary facilities.

making method

To make floor tile adhesive, mix SA100 powder with 5 liters of water.
Mixing the powder with water should be done using an electric mixer.
Add the powder slowly to the water and continue mixing for 3 minutes until a uniform and homogeneous dough is obtained.
Leave the prepared dough alone for 5 minutes and repeat the mixing process for 2 minutes.
The concentration of glue should be adjusted according to the type of work in such a way that after installing the tile on the surface, it will not be easily separated from the surface at the same moment, if it is separated, the back of the tile will be covered with glue.
If the glue concentration is high and the paste is hardened, the tile or ceramic will not stick on it.
The use of concrete glue with a high percentage increases the elastic properties of mortar against structural movements and cracking.
To make reinforced tile adhesive, each 20 kg bag of adhesive is mixed with 5400 to 6000 grams of diluted solution of concrete adhesive with water in a ratio of (1:1) or (1:2).
The specific weight of the ready adhesive with the diluted concrete adhesive composition is 1.65 to 1.75 kilograms per liter.

Safety tips

Avoid direct and permanent contact of this substance with the skin.
As a chemical substance, protective gloves and safety glasses should be used to avoid contact with skin or eyes.
In case of accidental contact with the skin or eyes, it should be washed with plenty of water.