This material is produced on the basis of mineral powders, cement, concentrators and polymer additives in a single component form, which is ready for consumption only by adding water.
Powder
White
1.60 0.02
None
It is available in 20 kg packs.
In normal temperature and humidity conditions, powder tile adhesive (SA90) lasts 45 minutes.
Spread the glue on the surface with a spatula or toothed trowel and place the block on it.
Install the block by applying pressure on the surface and move it slowly in place for better adhesion while pressing.
After installation, at least 60% of the back of the block must be covered with glue, otherwise, a trowel with deeper grooves should be used.
The blocks must be installed on the glued bed within 20 minutes.
The prepared glue should be used within one hour according to the ambient temperature.
Do not use at temperatures below 5 degrees Celsius.
The best temperature for glue drying is above 15 degrees Celsius.
Aryashimi’s technical department is ready to cooperate and provide services in order to provide technical advice and how to use its products correctly.
It can be used for up to 12 months if kept in the recommended conditions and in the original packaging.
It should be kept away from cold and frost and direct sunlight and at a temperature of +5 to +35 degrees Celsius.
According to the type of surface under work, the level of roughness and the type of grooves behind the tile, about 2.5 to 4 kilograms of SA80 powder is needed to cover one square meter.
The curing time for tiles installed on water absorbing sections is after 24 hours, and for non-absorbing sections or tiles with large dimensions, it takes a longer time.
Use waterproof sealants in bathrooms and sanitary facilities.
The work surface must be healthy, smooth, clean, free of grease effects, dry and free from any dust, paint and loose particles.
Surfaces with high water absorption should be saturated with acrylic primer or concrete glue before implementation.
Avoid direct and permanent contact of this substance with the skin.
As a chemical substance, protective gloves and safety glasses should be used to avoid contact with skin or eyes.
In case of accidental contact with the skin or eyes, it should be washed with plenty of water.
To make floor tile adhesive, mix SA90 powder with 5 liters of water.
Mixing the powder with water should be done using an electric mixer.
Add the powder slowly to the water and continue mixing for 3 minutes until a uniform and homogeneous dough is obtained. The amount of glue concentration should be adjusted according to the type of work in such a way that after installing the tile on the surface, it will not be easily separated from the surface at the same moment.
If the glue concentration is high and the paste is hardened, the tile or ceramic will not stick on it.
The use of concrete glue with a high percentage increases the elastic properties of mortar against structural movements and cracking.
To make reinforced tile adhesive, each 20 kg bag of adhesive is mixed with 5400 to 6000 grams of diluted solution of concrete adhesive with water in a ratio of (1:1) or (1:2).
The specific weight of the ready adhesive with the diluted concrete adhesive composition is 1.65 to 1.75 kilograms per liter.
Leave the prepared dough alone for 5 minutes and repeat the mixing process for 2 minutes.
It is used to install absorbent and non-absorbent tiles, ceramics, stones and mosaics up to 100 x 100 cm on horizontal surfaces inside the building.
