This material is produced on the basis of mineral powders, cement, thickening materials and polymer additives in a single part, which is only with Add water and it is ready to use
It is produced on the basis of mineral powders, cement, thickening materials and polymer additives in a single part, which is ready for consumption only by adding water.
Installation of absorbent and non-absorbent tiles, ceramics, stones and mosaics up to 1.00 x 1.00 is used on horizontal surfaces and inside the building.
Physical state: powder
Color: gray
Powder specific gravity: 𝑔 /𝑐𝑚3 1.60±0.02
Yon Keller: No
According to the type of surface under the work, the amount of unevenness and the shape of the grooves on the back of the tile, about 2.5 to 4 kilograms of ARYA SET powder –
SA90 is needed to cover one square meter.
The work surface must be healthy, smooth, clean, free of grease, dry and free from any dust, paint and loose particles.
The composition of this product can be used for leveling, aligning and removing partial unevenness of sections under the work up to 5 mm thickness, of course, enough time is required for drying.
To make the floor adhesive, mix SA90 powder with 5 liters of water.
Mixing the powder with water should be done using an electric mixer.
Slowly add the powder to the water and continue mixing for 3 minutes until a homogeneous paste is obtained.
Leave the prepared dough for 5 minutes and repeat the mixing process for 2 minutes.
The amount of glue concentration should be adjusted according to the type of work in such a way that after installing the spacer on the surface at the same moment
It should not be easily separated from the surface, if the back tile is separated, it should be covered with glue.
If the glue concentration is high and the paste is hardened, the tile or ceramic will not stick on it.
The use of concrete glue with a high percentage increases the elastic properties of mortar against structural movements and cracks.
For making reinforced tile adhesive, each 20 kg packet of adhesive contains 5400-6000 grams of diluted solution of concrete adhesive with water.
It is mixed in a ratio of (1:1) or (1:2).
The specific weight of the prepared adhesive with the diluted concrete adhesive composition is 1.65 to 1.75 kg/liter.
Spread the toothed spatula on the surface and place the tile on it.
Install the tile by applying pressure on the surface and move it slowly in place while pressing for better adhesion.
After installation, at least 60% of the back of the tile should be covered with glue, otherwise, a trowel with deeper grooves should be used.
The tiles must be installed on the glued substrate within 20 minutes.
The prepared adhesive should be used within one hour according to the ambient temperature.
Do not use at a temperature of less than 5 degrees Celsius.
The best temperature for glue drying is above 15 degrees Celsius.
The curing time for tiles installed on water absorbent sections is after 24 hours and for sections without absorption or tiles with dimensions
Big is in a longer period of time.
Use waterproof sealants in bathrooms and toilets.
20 kg bags are available
Keep away from moisture and direct sunlight and at a temperature of +5 to +35 degrees Celsius.
It can be used for up to 12 months if kept in the recommended conditions and in the original packaging.
Direct and permanent contact of this substance with the skin should be avoided.
as a chemical substance and observing precautionary measures to prevent contact with skin or eyes from protective gloves and glasses
Be safe to use
In case of accidental contact with skin or eyes, it should be washed with plenty of water.
Aryashimi technician is ready to cooperate and provide services in order to provide technical advice and how to use her product correctly.
